Discontinued Item: This item is discontinued. Please CALL to see if there is a replacement or an alternative.

Intake Manifold -Polished Crosswind, Chevy Small Block Vortec Heads (Non Egr) Photo Main
(Mouse over any image to view)
Intake Manifold -Polished Crosswind, Chevy Small Block Vortec Heads (Non Egr) Photo Main

Share |



Product Description

Item # PP-52027
Weighs 25.000lbs.

The polished Power+Plus CrossWind for the Vortec features the same plenum and runner design as our popular 52020/52021 and 52025/52026 manifolds. In this design the manifold is made wider to accommodate the Vortec design heads and also features the Vortec port configuration. The manifold also has a square bore carb pad to utilize the standard Holley, Carter and Edelbrock carburetors. This manifold is intended for use on up through 95 blocks using the 1996 and later Vortec (Gen 1+) heads or Edelbrock E-Tec heads. It can also be used on 96 and later Vortec engines with some minor modifications. The modification is not to the manifold itself. It just requires running a short section of heater hose from the pipe tapped hole in the front of the manifold to the 5/8" hose nipple on passenger's side of the water pump. The 1966 and later Vortec blocks do not have a water bypass in the block and this hose takes care of that issue. RPM range 1500 to 6500.

This part fits most Chevrolet Cars and Trucks.; exceptions may apply. Please read the complete description to see if this part fits your specific vehicle and application.

Discontinued Item

Leave a product Review
Additional Category Items

Product Fits Vehicle Models

Product Reviews

TOP